Documentation Errors

I noticed in the SiFive HiFive Premier P550 Getting Started Guide Early Access Edition v1.2 in Section 5 Hardware Introduction, section 5.1, that Figure 5.1: ATX Power connector pin out. The figure is wrong, it does not match the standard and it does not match the pinout of the power supply sipplied with the board. The correct information is below:

24-Pin ATX Main Power Connector Pinout

Pin Signal / Voltage Wire Color Pin Signal / Voltage Wire Color
1 +3.3V Orange 13 +3.3V (or +3.3VSense) Orange (Brown/Orange)
2 +3.3V Orange 14 -12V Blue
3 Ground (COM) Black 15 Ground (COM) Black
4 +5V Red 16 PS-ON# (Power On) Green
5 Ground (COM) Black 17 Ground (COM) Black
6 +5V Red 18 Ground (COM) Black
7 Ground (COM) Black 19 Ground (COM) Black
8 Power Good (PWR_OK) Gray 20 -5V (Optional/Legacy) White
9 +5V Standby (+5VSB) Purple 21 +5V Red
10 +12V Yellow 22 +5V Red
11 +12V Yellow (or 16 AWG) 23 +5V Red
12 +3.3V Orange 24 Ground (COM) Black

The pinout in Premier P550 documentation matches the board schematic, Intel ATX specifications (Rev 2.1a, figure 5-2 and table 5-1) and @gdhhunt’s pinout above - see the attached images comparing showing all of them together. The pinout shown above and Intel specifications show the connector from the top, Premier P550 documentation shows it from the bottom.

Thanks for the clarification. It might be good to point out which way to interpret the figure.