I really don’t know how to solve it.
terminal turns that:
work/build/openocd/prefix/bin/openocd -f bsp/env/sirv-e203-arty/openocd.cfg &
/home/hbking/documents/rocket-chip/e200_opensource/sirv-e-sdk/work/build/riscv-gnu-toolchain/riscv32-unknown-elf/prefix/bin/riscv-none-embed-gdb software/demo_gpio/demo_gpio --batch -ex “set remotetimeout 240” -ex “target extended-remote localhost:3333” -ex “monitor reset halt” -ex “monitor flash protect 0 64 last off” -ex “load” -ex “monitor resume” -ex “monitor shutdown” -ex “quit” &&
echo “Successfully uploaded ‘demo_gpio’ to sirv-e203-arty.”
GNU MCU Eclipse 64-bits Open On-Chip Debugger 0.10.0+dev-00084-gae68d7da-dirty (2018-09-26-15:31)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
adapter speed: 1000 kHz
Info : auto-selecting first available session transport “jtag”. To override use ‘transport select <transport>’.
Info : clock speed 1000 kHz
Error: JTAG scan chain interrogation failed: all ones
Error: Check JTAG interface, timings, target power, etc.
Error: Trying to use configured scan chain anyway…
Error: riscv.cpu: IR capture error; saw 0x1f not 0x01
Warn : Bypassing JTAG setup events due to errors
Error: Unsupported DTM version: 15
Info : Listening on port 3333 for gdb connections
Error: Target not examined yet
Error: Unsupported DTM version: 15
Warn : Flash driver of my_first_flash does not support free_driver_priv()
localhost:3333: Connection timed out.
“monitor” command not supported by this target.
“monitor” command not supported by this target.
You can’t do that when your target is `exec’
“monitor” command not supported by this target.
“monitor” command not supported by this target.
Successfully uploaded ‘demo_gpio’ to sirv-e203-arty.