Unit seems to be bricked. Can I reflash it to factory?

[dmc (Dennis)]

Good question. Well it had a blinking led on it that would run through the colors red green and blue. Doesn’t do that anymore but it once did.

I set it to “safe mode” however still can not connect to it at all.

Board seems to be a warm brick and nonresponsive

Have not done much other than the compile the dhrystone code and then attempt to upload it to the unit. That resulted in a pile of errors. At the moment there are two green leds lit up and when I press the “reset” button I see a single blue led flash once. Then nothing but the two green leds are on. There are no /dev/ttyUSB? entries created and lsusb claims the unit is not attached at all. That to me is a warm brick. Is this thing now a fridge magnet ? Note that page 22 of the “Getting Starte…