Hi all,
We have uploaded a 3D printed case for the Microsemi HiFive Unleashed Expansion Board. It is available here under expansion-case:
This is the board:
Happy hacking,
-Jeff
Hi all,
We have uploaded a 3D printed case for the Microsemi HiFive Unleashed Expansion Board. It is available here under expansion-case:
This is the board:
Happy hacking,
-Jeff
Does everything line up properly after assembly? I am concerned about wasting a lot of filament for nothing.
Ya, it all lines up. You likely can’t run it with the cover on though, if you are using a PCI card for video, for example. So you probably just want to print the lower half.
What screws did you use to connect all the pieces together? Thanks for the help.
@ryanmendels There is a full bill of materials in LibreOffice Calc format here: